Design of an eight-megawatt series regulator

An 8-MW, 100 percent duty cycle, hard tube series regulator used to control the accelerating voltage of a neutral beam source is described. The series tube is a developmental switch/regulator tube capable of holding off 200 kV passing 85 A, and dissipating 2 MW of anode power. The regulator has high-speed interrupt capability to minimize the power delivered to the load in the event of a load fault. Its design is such that it can be used to regulate both positive and negative accelerating voltages. All reference/control signals between the modulator and the control station use optical links to minimize noise interference and ground loop problems. In all cases of optical coupling, the loss of light is the worst-case condition, i.e., loss of light turns off the regulator. The fast interrupt is accomplished by rapid removal of the screen grid voltage from the series tube, and then driving the control grid into cutoff. After the control grid is in cutoff the screen is allowed to recover, and the regulator is then ready to switch back on. The regulator tube driver is a straightforward dc-coupled amplifier with a cathode follower output; dc isolation between various sections of the modulator is accomplished by using optical coupling. The use of optics allows the use of solid-state devices in an extremely hostile environment containing both electromagnetic and nuclear radiation