Root cause study on the high levels of reactor water silica and its measures for reduction in Taiwan BWRs

Water temperature in condenser hot well can change significantly with the seasons. It is not unusual for silica levels in reactor water to increase in the summer and to decrease during winter. Also it seems that silica levels in reactor water of domestic nuclear power plants increased slowly from 200 ppb to the high side above 500 ppb as condensate polishing resin non-regeneration throw away action has been adopted in recent seven years. Through both the on-line silica monitoring of condensate demineralizer and silica analysis of subsequent precoat test in reactor water clean up system, the result obtained from steam/liquid mass balance calculation indicated that an increase of reactor water silica was mainly caused by continuing equilibrium leakage from deep bed condensate demineralizers, where the ion exchange zone is periodically disturbed by resin backwashing-scrubbing operation. The fastest and effective way to reduce the silica inventory in reactor system is to operate by frequent backwashes and precoating of the reactor water clean up filter demineralizers to a lower effluent silica end point, perhaps as frequently as three or four days. Periodic replacement of the oldest and/or most heavily loaded resins could perform a radical cure to reduce silica content in reactor water. During summer season, increased filter demineralizer precoat frequency would get over the problem of system short-term silica equilibrium leakage. (author)