Tailoring the size and distribution of Ag nanoparticles in silica glass by defects

The composites embedded with metallic nanoparticles show large nonlinear optical susceptibility and strong surface plasmon resonance absorption, which enable potential application in opto-electronics. Ion implantation has been proven to be a powerful technique of synthesis of metallic nanoparticles due to its versatility and compatibility. However, the synthesis of nanoparticles by ion implantation inevitably leads to a broad size distribution due to Ostwald ripening process. The broad size distribution has a negative effect on improving the figure of merits for nonlinear optics. In this paper, we tried to introduce defects in silica glass to act as pre-nucleation centers to mediate the size and distribution of Ag nanoparticles. In experiment, the silica glass samples were pre-irradiated by 200 keV Ar ions to fluences of 0.8, 2.0 and 5.0 × 1016 ions/cm2, and then 200 keV Ag ions were implanted into the pre-irradiated samples to fluence of 2.0 × 1016 ions/cm2. UV–VIS results show that the absorbance intensity of Ag SPR peak initially increases and then decreases with pre-irradiation fluence, which implies the change in size and density of Ag nanoparticles in samples. TEM results verify that Ag nanoparticles in the sample pre-irradiated to the fluence of 0.8 × 1016 ions/cm2 grow bigger and distribute in a relatively narrow region comparing with that without pre-irradiation. With further increase of pre-irradiation fluence, the size of Ag nanoparticles shows a depth dependent distribution. A boundary can be clear seen at the depth of 110 nm, larger Ag nanoparticles disperse in region shallower than 110 nm, and smaller Ag nanoparticles disperse in the region deeper than 110 nm. The average size of Ag nanoparticles initially increases and then decreases with pre-irradiation fluence. Therefore, the introduction of defects by pre-irradiation could be an effective way to tailor the size and distribution of metallic nanoparticles in matrix