Published February 15, 2016 | Version v1
Journal article

Experimental evaluation of the effect of wave focusing walls on the performance of the Sea-wave Slot-cone Generator

  • 1. Faculty of Engineering of the University of Porto, Department of Civil Engineering, Rua Dr. Roberto Frias, s/n, 4200-465 Porto (Portugal)
  • 2. Interdisciplinary Centre of Marine and Environmental Research (CIIMAR), Faculty of Engineering of the University of Porto, Department of Civil Engineering, Rua Dr. Roberto Frias, s/n, 4200-465 Porto (Portugal)
  • 3. Institute of Science and Innovation in Mechanical and Industrial Engineering (INEGI), Rua Dr. Roberto Frias, s/n, 4200-465 Porto (Portugal)

Description

Highlights: • The application of the Sea-wave Slot-cone Generator (SSG) in breakwaters is promising. • The use of wave focusing walls (WFW) improves the performance of the SSG technology. • The WFW concentrate the incident wave energy and increase the overtopping flow rates. • The design of new SSG devices should take into account the eventual use of WFW. • The use of WFW increased the annual energy production approximately to the double. - Abstract: The Sea-wave Slot-cone Generator (SSG) is a multi-level overtopping based wave energy converter that can be installed either nearshore or offshore. The installation in harbor breakwaters and in the shoreline presents several advantages despite the usual exposure to smaller waves than at offshore locations. This work analyzes the effect of wave focusing walls (i.e., wave concentrators) on the performance of isolated SSG units using a physical model built on a geometric scale of 1/40. Seven configurations were defined by changing the opening angle and the crest level of those elements. The use of wave concentrators proved to be advantageous since a wider wave front is captured and the run-up and overtopping phenomena are enhanced on the SSG ramp owing to the wave energy concentration (walls tapering effect). In fact, the total mean power captured increased for all SSG configurations with concentrators in comparison to the base configuration (without concentrators), regardless of the sea state considered. In terms of hydraulic performance, the gain associated to the use of wave concentrators depends on the characteristics of incident waves, being higher for the smaller significant wave heights and the shorter peak wave periods. The hydraulic efficiency, defined as the ratio between the total mean power captured per meter of SSG width and the wave power per meter width of the incident waves, increases with the significant wave height and reduces with the peak wave period in all tested SSG configurations. In addition, in comparison to the base configuration, the hydraulic efficiencies with concentrators were higher for the smaller significant wave heights, but smaller for the other sea conditions. The use of wave concentrators increased the annual energy production approximately to the double. Overall, the application of the SSG technology in breakwaters presents itself as promising considering the characteristics of the wave resource nearshore or even in onshore locations.

Availability note (English)

Available from http://dx.doi.org/10.1016/j.enconman.2015.11.071

Additional details

Identifiers

DOI
10.1016/j.enconman.2015.11.071;
PII
S0196-8904(15)01103-6;

Publishing Information

Journal Title
Energy Conversion and Management
Journal Volume
110
Journal Page Range
p. 165-175
ISSN
0196-8904
CODEN
ECMADL

Optional Information

Copyright
Copyright (c) 2015 Elsevier Science B.V., Amsterdam, The Netherlands, All rights reserved.