Published January 2008 | Version v1
Journal article

Effects of paste composition and heat-treatment conditions on the microstructure of polycrystalline CdS1-xSex films

  • 1. Moskovskaya Gosudarstvennaya Akademiya Tonkoj Khimicheskoj Tekhnologii im. M.V. Lomonosova, Moscow (Russian Federation)
  • 2. NANB, Inst. Ehlektroniki, Minsk (Belarus)
  • 3. Moskovskij Gosudarstvennyj Univ. im. M.V. Lomonosova, Moscow (Russian Federation)
  • 4. RAN, Inst. Teoreticheskoj i Prikladnoj Ehlektrodinamiki, Moscow (Russian Federation)

Description

The flux content, synthesis procedure, and grinding conditions of CdS1-xSex powders used for paste preparation are studied for their effect on the composition and microstructure of films produced by screen printing. The results demonstrate that, to obtain single-phase polycrystalline CdS1-xSex films with well-formed grain boundaries, the flux content of the paste must lie in the range 10-12 wt %, and the solid solution with necessary dopants should be preliminarily synthesized. The powder must be ground to a particle size no greater than 6 μm

Abstract (Russian)

Исследовано влияние концентрации флюса, методики синтеза и помола порошка твердого раствора CdS1-xSex, используемого для приготовления пасты, на состав и микроструктуру пленок, синтезированных методом трафаретной печати. Показано, что для получения однофазных поликристаллических пленок CdS1-xSex с хорошо сформированными межзеренными контактами концентрация флюса в пасте должна составлять 10-12 мас. %, а твердый раствор с необходимыми легирующими добавками желательно синтезировать предварительно. Порошок должен быть размолот на частицы размером не более 6 мкм

Additional details

Additional titles

Original title (Russian)
Влияние состава пасты и режима термообработки на микроструктуру поликристаллических пленок CdS

Publishing Information

Journal Title
Neorganicheskie Materialy
Journal Volume
44
Journal Issue
1
Journal Page Range
p. 10-16
ISSN
0002-337X
CODEN
NEOMB8

Optional Information

Notes
5 refs., 8 figs., 2 tabs.