Published October 1, 1991 | Version v1
Journal article

Design and operation of large straw-tube drift chamber planes

  • 1. Physics and Astronomy Dept., Michigan State Univ., East Lansing, MI (United States)
  • 2. Physics Dept., Univ. of California, Davis, CA (United States)
  • 3. Dept. of Physics and Astrophysics, Delhi Univ. (India)
  • 4. Fermilab, Batavia, IL (United States)
  • 5. Dept. of Physics, Northeastern Univ., Boston, MA (United States)
  • 6. Dept. of Physics and Astronomy, Univ. of Oklahoma, Norman, OK (United States)
  • 7. Dept. of Physics, Pennsylvania State Univ., University Park, PA (United States)
  • 8. Dept. of Physics and Astronomy, Univ. of Pittsburgh, PA (United States)
  • 9. Dept. of Physics and Astronomy, Univ. of Rochester, NY (United States)

Description

We describe the design, construction and operation of a straw-tube drift chamber consisting of four X and four Y planes of 16 mm diameter straw-tubes, each 280 cm long. Straws were glued together for rigidity and were mounted into a frame which served as a gas manifold and maintained wire-to-wire precision. A novel conductive gasket was used to seal the tubes and provide electrical contact to the aluminized surface of the straws. The chamber has been successfully used in a high rate experiment (E706 at Fermilab) and has achieved its design resolution of better than 250 μm per tube averaged over the whole chamber. (orig.)

Additional details

Publishing Information

Journal Title
Nuclear Instruments and Methods in Physics Research. Section A
Journal Volume
307
Journal Issue
2/3
Series
Nucl. Instrum. Methods Phys. Res., Sect. A.
Journal Page Range
292-297
ISSN
0168-9002
CODEN
NIMAE