Prediction of CANDU-6 moderator system response following a large break LOCA using a 3D model

CANDU nuclear reactors use D20 as a moderator inside the calandria vessel. Heat is generated in the calandria by neutron and gamma radiation from nuclear fission. During normal operating condition, hot moderator fluid is continuously pumped out from the bottom of the CANDU-6 calandria. After passing through a heat exchanger, the cooled moderator fluid is returned to the calandria through inlet nozzles. In the unlikely event of a loss of coolant accident (LOCA) the moderator acts as a heat sink. To predict moderator system response following a large break (reactor inlet header break) LOCA, a simulation was undertaken for Class IV power available (i.e. main moderator pump running) as well as for Class IV power unavailable during the LOCA. The analysis was performed to facilitate the assessment of fuel channel integrity following pressure tube (PT) and calandria tube (CT) contact by estimating the subcooling available during the inlet header break. The 3D code PHOENICS2 developed by CHAM U.K was used for the simulation. The results show an asymmetric flow pattern within the moderator both in the axial Z-direction of the calandria as well as in the X-Y plane. The temperature distribution within the moderator system shows, that hot spots are generated in areas, where the flow approaches stagnation. Hot spot temperatures are higher with Class IV power unavailable. (author). 1 ref., 12 figs