Studies on the weldability, mechanical properties and microstructural characterization of activated flux TIG welding of AISI 321 austenitic stainless steel

The presence of titanium in AISI 321 austenitic stainless steel, mitigates the corrosion when deployed in specific applications such as boiler shells, aircraft exhaust manifolds and process equipment. Using Commercial flux purchased from Edison Welding Institute (EWI), studies were conducted to note the effect of Activated Tungsten Inert gas (A-TIG) welding on the surface morphology of type 321 austenitic stainless steel welds and compared with conventional TIG welding. A thin flux layer was applied to the surface of the 6 mm thick plate, followed by a conventional TIG welding process. The bead on trial results shows that compared with the TIG welding process, the flux causes the weld depth to increase, weld bead width to decrease and weld area to increase. This incredible depth of penetration (DOP) has been accomplished by the mechanisms of reversal of Marangoni flow and Arc constriction. From various experimental trials, arc length of 3 mm, welding current of 220 Amps and welding speed of 120 mm min⁻¹ were found to be optimal and subsequently used as input parameters to produce a good quality A-TIG welded butt joint. The welded joint is subjected to transverse and longitudinal tensile and bend tests, charpy impact toughness tests, microhardness, optical microscope, x-ray diffraction analysis, ferrite number measurement and Scanned electron fractography. The welded joint exhibited improved tensile strength, bend and charpy impact toughness and hardness. The weld metal microstructure was observed to be austenite, delta-ferrite and TiC intermetallic compounds (Titanium carbides). The XRD pattern indicates that austenite and ferrite phases are present in both base and weld metal. The results of Fischer Feritscope FMP30 (ferrite measurement) show that the content of delta-ferrite in the weld metal (5.9 FN) is much higher than the parent metal (1.2 FN) and shows excellent mechanical properties in the A-TIG welded joint. Scanned electron fractography indicates that the failure of weld metal and base metal occurs in the ductile mode of fracture. (paper)