Published November 1, 2016 | Version v1
Journal article Metadata-only

Research of annealing mode for high accuracy stamped parts production from titanium alloy 83Ti-5Al-5Cr-5Mo after tooling

Creators

  • 1. Samara University, 34, Moskovskoye Shosse, Samara (Russian Federation)

Description

The aim of the work is to solve question of accuracy increase in tolled and annealed parts made from forged rod of titanium alloy. Plate pieces were cut from cross-section, annealed at 800°C during 1, 2, 3, 4 and 5 hours. The criterion combining minimum bending radius and spring back angle was found. This criterion shows the maximum values after tooling and annealing for 3 hours. (paper)

Availability note (English)

Available from http://dx.doi.org/10.1088/1757-899X/156/1/012003

Additional details

Identifiers

DOI
10.1088/1757-899X/156/1/012003;

Publishing Information

Journal Title
IOP Conference Series. Materials Science and Engineering (Online)
Journal Volume
156
Journal Issue
1
Journal Page Range
[5 p.]
ISSN
1757-899X

Conference

Title
International conference and youth scientific school on materials and technologies of new generations in modern materials science
Dates
9-11 Jun 2016
Place
Tomsk (Russian Federation)

INIS

Country of Publication
United Kingdom
Country of Input or Organization
International Atomic Energy Agency (IAEA)
INIS RN
49074143
Subject category
S36: MATERIALS SCIENCE;
Resource subtype / Literary indicator
Conference
Descriptors DEI
ACCURACY; ALUMINIUM ALLOYS; ANNEALING; CHROMIUM ALLOYS; CROSS SECTIONS; MOLYBDENUM ALLOYS; PLATES; QUATERNARY ALLOY SYSTEMS; RODS; SPRINGS; TITANIUM ALLOYS; TOOLS
Descriptors DEC
ALLOY SYSTEMS; ALLOYS; EQUIPMENT; HEAT TREATMENTS; MACHINE PARTS; TRANSITION ELEMENT ALLOYS