Synthesis of sulphonated mesoporous phenolic resins and their application in esterification and asymmetric aldol reactions
Creators
- 1. Department of Inorganic and Physical Chemistry, Ghent University, Center for Ordered Materials, Organometallics and Catalysis (COMOC), Krijgslaan 281-S3, 9000 Ghent (Belgium)
- 2. Associated Faculty of Applied Engineering Sciences, University College Ghent, Valentin Vaerwyckweg 1, 9000 Ghent (Belgium)
- 3. Katholieke Universiteit Leuven, Centre for Surface Chemistry and Catalysis (COK), Kasteelpark Arenberg 23, 3001 Heverlee (Belgium)
Description
Mesoporous phenolic resins were functionalized with sulphonic acid groups by four different types of sulphonation procedures: (i) direct sulphonation on the aromatic ring, (ii) alkyl sulphonation of the aromatic ring, and functionalizations of the phenolic hydroxyl surface by using an aryl silane, 2-(4-chlorosulphonylphenyl)ethyl trichlorosilane (iii) or a propyl silane, 3-mercaptopropyltrimethoxysilane (iv). The highest acidity loadings were obtained through direct sulphonation with fuming sulphuric acid (1.90 mmol H+ g−1) or chlorosulphonic acid (1.31 mmol H+ g−1) and these materials showed the highest conversion (97+ %) in Fischer esterification of acetic acid with propanol. However, the alkyl sulphonic groups, obtained through sulphonation procedure (ii) showed the highest stability in terms of maintenance of their acidity after use in consecutive catalytic runs or leaching treatments. This was demonstrated both through evaluation of the regenerated catalysts in a consecutive esterification run and during a leaching resistance test in aqueous medium. Moreover, the developed sulphonated mesoporous phenolic resins are presented as novel support for the non-covalent immobilization of an L-phenylalanine derived chiral diamine organocatalyst for asymmetric aldol reactions. The immobilization is established by an acid–base interaction between the sulphonic acid group and the amine function. The acidity and in particular the electronic withdrawing environment of the sulphonic acid groups influence enormously the catalytic performance of the non-covalent immobilized chiral diamine catalyst (aromatic > aliphatic). - Highlights: ► Different types of sulphonation procedures for mesoporous phenolic resins. ► Influence of acidity and electronic withdrawing environment. ► Novel support for non-covalent immobilization of chiral diamine catalyst. ► Catalytic performance in esterification and asymmetric aldol condensation. ► Demonstration of leaching resistance in aqueous medium
Availability note (English)
Available from http://dx.doi.org/10.1016/j.matchemphys.2012.11.032Additional details
Identifiers
- DOI
- 10.1016/j.matchemphys.2012.11.032;
- PII
- S0254-0584(12)00973-X;
Publishing Information
- Journal Title
- Materials Chemistry and Physics
- Journal Volume
- 138
- Journal Issue
- 1
- Journal Page Range
- p. 131-139
- ISSN
- 0254-0584
- CODEN
- MCHPDR
INIS
- Country of Publication
- Netherlands
- Country of Input or Organization
- International Atomic Energy Agency (IAEA)
- INIS RN
- 45108642
- Subject category
- S37: INORGANIC, ORGANIC, PHYSICAL AND ANALYTICAL CHEMISTRY; S36: MATERIALS SCIENCE;
- Descriptors DEI
- CHIRALITY; NANOSTRUCTURES; PHENOLS; PHENYLALANINE; RESINS; SULFONATES; SURFACE PROPERTIES
- Descriptors DEC
- AMINO ACIDS; AROMATICS; CARBOXYLIC ACIDS; HYDROXY COMPOUNDS; ORGANIC ACIDS; ORGANIC COMPOUNDS; ORGANIC POLYMERS; ORGANIC SULFUR COMPOUNDS; PARTICLE PROPERTIES; PETROCHEMICALS; PETROLEUM PRODUCTS; POLYMERS
Optional Information
- Copyright
- Copyright (c) 2012 Elsevier Science B.V., Amsterdam, The Netherlands, All rights reserved.