Design of data acquisition system ZOH production process equipment of ZBS (zircon based sulfate)

Design of data acquisition system of ZOH maker unit from ZBS has performed. Design is done as a follow-up of The Design Flow stirred tank reactor (RATB) ZOH Making of ZBS is equipped with a data acquisition system. The design of the system is going to work based on constants or parameters that have been previously calculated. Design method begins with understanding the process description of ZBS ZOH continuous basis, identify the parameters to be observed. Description of the process need to know to determine the actuator is used, as for these parameters are used to determine the sensor to be used. The parameter are the detection of NH₄OH and ZBS reserves the feeder tank, flow rate ZBS and NH₄OH, the temperature inside RATB, RATB and pH , the produced flow rate of ZOH. Based on the calculation, in order to get the results needed ZOH ZBS will flow into the reactor at the rate of 10 ml/min simultaneously with NH₄OH with discharge flow 6.1 ml/min into the RATB 3 liters volume. When the volume reaches half tank RATB then start heating is turned on while the constant feed flow. Conditions of pH and temperature on the RATB always monitored by setting point pH at 10 while setting point temperature of 90°C. Monitoring parameters require gauge/transducer or a particular sensor. The study on the obtained results in the form of a flow chart design controller when controlling the process, when read and transmit data, and display the resulting data acquisition process parameters on the screen according to the parameters that was planned. (author)