Ice-templated hybrid graphene oxide—graphene nanoplatelet lamellar architectures: tuning mechanical and electrical properties

The traditional freeze-casting route for processing graphene-based aerogels is generally restricted to aqueously dispersed flakes of graphene oxide (GO) and post-processing reduction treatments, which brings restrictions to the aerogels electrical properties. In this work, we report a versatile aqueous processing route that uses the ability of GO todisperse graphene nanoplatelets (GNP) to produce rGO-GNP lamellar aerogels via unidirectional freeze-casting. In order to optimise the properties of the aerogel, GO-GNP dispersions were partially reduced by L-ascorbic acid prior to freeze-casting to tune the carbon and oxygen (C/O) ratio. The aerogels were then heat treated after casting to fully reduce the GO. The chemical reduction time was found to control the microstructure of the resulting aeorgels and thus to tune their electrical and mechanical properties. An rGO-GNP lamellar aerogel with density of 20.8 ± 0.8 mg cm⁻³ reducing using a reduction of 60 min achieved an electrical conductivity of 42.3 S m⁻¹. On the other hand, an optimal reduction time of 35 min led to an aerogel with compressive modulus of 0.51 ±0.06 MPa at a density of 23.2 ± 0.7 mg cm⁻³, revealing a compromise between the tuning of electrical and mechanical properties. We show the present processing route can also be easily applied to produce lamellar aerogels on other graphene-based materials such as electrochemically exfoliated graphene. (paper)