Elucidation of microstructural evolution of beta-type titanium alloy joint during friction stir welding using liquid CO2 cooling

Highlights: • Microstructural evolution during FSW was elucidated along real material flow line. • Stirring and cooling stages of FSW can be investigated separately using CO₂ cooling. • In stirring stage, discontinuous dynamic recrystallization predominantly occurred. • In cooling stage, static recovery and grain growth mainly occurred. - Abstract: Normal friction stir welding (FSW) and liquid CO₂ cooling FSW were conducted on the β-type Ti-15V-3Cr-3Al-3Sn (Ti-15-3, mass%) alloy plates under a processing condition. Since liquid CO₂ cooling with high cooling efficiency can freeze the microstructure formed during the high-temperature stirring stage of FSW, it is possible to separately elucidate the microstructural evolution of the Ti-15-3 alloy during the high-temperature stirring stage and the post-stirring cooling stage in FSW. The deformation temperature during the normal and the CO₂ cooling FSW was similar in the top and the bottom of stir zone, which is considered to be owing to that the top and bottom are located adjacent to the heat sources, i.e., the shoulder and probe surfaces. In the high-temperature stirring stage of FSW, discontinuous dynamic recrystallization predominantly occurred, and a simple shear texture generated in an early stage of the material flow around the tool, then the microstructure started to evolve steadily after a steady-state dynamic recrystallization. In the post-stirring cooling stage of FSW, static recovery and grain growth were found to mainly occur within the stir zone.