Corrosion of research reactor aluminium clad spent fuel in water. Additional information

A large variety of research reactor spent fuel with different fuel meats, different geometries and different enrichments in 235U are presently stored underwater in basins located around the world. More than 90% of these fuels are clad in aluminium or aluminium based alloys that are notoriously susceptible to corrosion in water of less than optimum quality. Some fuel is stored in the reactor pools themselves, some in auxiliary pools (or basins) close to the reactor and some stored at away-from-reactor pools. Since the early 1990s, when corrosion induced degradation of the fuel cladding was observed in many of the pools, corrosion of research reactor aluminium clad spent nuclear fuel stored in light water filled basins has become a major concern, and programmes were implemented at the sites to improve fuel storage conditions. The IAEA has since then established a number of programmatic activities to address corrosion of research reactor aluminium clad spent nuclear fuel in water. Of special relevance was the Coordinated Research Project (CRP) on Corrosion of Research Reactor Aluminium Clad Spent Fuel in Water (Phase I) initiated in 1996, whose results were published in IAEA Technical Reports Series No. 418. At the end of this CRP it was considered necessary that a continuation of the CRP should concentrate on fuel storage basins that had demonstrated significant corrosion problems and would therefore provide additional insight into the fundamentals of localized corrosion of aluminium. As a consequence, the IAEA started a new CRP entitled Corrosion of Research Reactor Aluminium Clad Spent Fuel in Water (Phase II), to carry out more comprehensive research in some specific areas of corrosion of aluminium clad spent nuclear fuel in water. In addition to this CRP, one of the activities under IAEA's Technical Cooperation Regional Project for Latin America Management of Spent Fuel from Research Reactors (2001-2006) was corrosion monitoring and surveillance of research reactor aluminium clad spent fuel. These corrosion activities were quite similar to those carried out in the CRP. Eight Member States participated in Phase-II of the CRP and five Member States in the Regional Project RLA/4/018. Two of the countries participating in the regional project were also participants in the CRP. This report documents the work performed in the IAEA Coordinated Research Project (CRP) on Corrosion of Research Reactor Aluminium Clad Spent Fuel in Water (Phase II) and in the IAEA's Technical Cooperation Regional Project for Latin America (RLA/4/018) entitled Management of Spent Fuel from Research Reactors. The key activity of both, the CRP and the Regional Project, consisted of the exposure of standard racks of corrosion coupons in the spent fuel pools of the participating research reactor laboratories and the evaluation of the coupons after predetermined exposure times, along with periodic monitoring of the storage water and evaluation of sediments settling in the spent fuel pools. The report includes: a description of the standard corrosion racks, experimental protocols, test procedures and water quality monitoring; the specific contributions by each of the participating laboratories; a compilation of all experimental results obtained and the analysis and discussion of the results, along with conclusions