Structural modelling and testing of failed high energy pipe runs: 2D and 3D pipe whip

The sudden rupture of a high energy piping system is a safety-related issue and has been the subject of extensive study and discussed in several industrial reports (e.g. ). The dynamic plastic response of the deforming pipe segment under the blow-down force of the escaping liquid is termed pipe whip. Because of the potential damage that such an event could cause, various geometric and kinematic features of this phenomenon have been modelled from the point of view of dynamic structural plasticity. After a comprehensive summary of the behaviour of in-plane deformation of pipe runs that deform in 2D in a plane, the more complicated case of 3D out-of-plane deformation is discussed. Both experimental studies and modelling using analytical and FE methods have been carried out and they show that, for a good estimate of the 'hazard zone' when unconstrained pipe whip motion could occur, a large displacement analysis is essential. The classical, rigid plastic, small deflection analysis (e.g. see ), is valid for estimating the initial failure mechanisms, however it is insufficient for describing the details and consequences of large deflection behaviour. - Highlights: → Dynamic plastic response of piping system under extreme loading (fluid escape). → Two and three dimensional analysis of the pipe whipping phenomena. → Comparison between theory and the experiments. → Determination of the Hazard Zone (HZ) and safety-related issues.