An isothermal forming process with multi-stage variable speed for magnesium component assisted by sensitivity analysis

We have developed a multi-stage variable speed (MSV) isothermal forming process based on strain rate sensitivity (SRS) analysis, and successfully produced a large size of rib-web component of magnesium alloy from a cylindrical billet. The obtained rib-web component has been processed into parts for mechanical properties examination and the examination results met the standard of being safely used in aircrafts. The process parameters of the forming technology and microstructure change were explicitly linked by the SRS coefficient. The finite element (FE) simulation and SRS distribution were implemented to identify the relationship among process parameters, shaping characteristics, and microstructure development. The MSV speed process was employed for reducing the forming load, refining grain sizes and increasing the strength of the component. With the selected process parameters the maximum forming load was reduced to be less than 20 MN, which is 55.3% lower than that used in the same process with the initial constant speed unchanged. Fine dynamic recrystallization (DRX) were observed from all parts of the forged cover plate including the convex, ribs, and web region. It was also found that higher strain resulted in more uniform distribution of fine β-Mg₁₇Al₁₂ precipitates and larger DRX volume fraction. Importantly the developed isothermal forming process with severe plastic deformation can be applied for obtaining grain refinement so improving the mechanical properties of Mg products.