Distribution of the beam density at the target of subcritical facility "Neutron Source"

NSC KIPT subcritical facility "Neutron Source" uses rectangular tungsten or uranium target of 64×64 mm top cross-section. To generate maximum neutron flux, prevent overheating of the target and reduce thermal stress dur-ing the facility power operation one should provide uniform electron beam distribution at the target top surface. During the facility design three different possibilities of electron beam density redistribution above the target surface were considered. These were the fast beam scanning with two dimensional scanning magnets; the method of uniform beam distribution formation with linear focusing elements (dipole and quadrupole magnets) and nonlinear focusing elements (octupole magnets), when final required rectangular beam shape with homogeneous beam density is formed at target; and combined method, when one forms the small rectangular beam with homogeneous beam density distribution and scan it over the target surface with scanning magnets. In the paper the all three methods are considered and discussed taking into account the layout of the transportation channel of NSC KIPT subcritical facility "Neutron Source". For the first stage of the facility start-up and pilot operation the fast scanning method was chosen, realised and tested. The results of the beam distribution measurements over the surface of the target during the facility adjustment and start up are presented.