Spray forming of glass former Fe63Nb10Al4Si3B20 alloy

In this study the Fe63Nb10Al4Si3B20 (at.%) alloy was processed by spray forming with the aim of investigate the formation of amorphous phases and novel microstructures by the high cooling rate involved in this process. The gas/metal mass flow rate used was 0.25, and nitrogen was used as the atomization gas. The resulting deposit of a mass of about 1.2 kg, as well as the overspray powder, with a median particle diameter about 120 μm, were characterized by using X-ray diffractometry, differential scanning calorimetry and scanning and transmission electron microscopy with energy of dispersive spectroscopy. Magnetic properties were measured through hysteresis loop tracer equipment. The overspray powder presented a mass median diameter of d 50 ≅ 120 μm and an increasing of amorphous phase volume fraction with decreasing of particle size. The microstructure of the deposit was heterogeneous varying with the thickness, presenting at center region 20 mm and at border 1 mm with different porosities 5 and 10%, respectively. The thicker region presented fully crystalline microstructure whereas the thinner presented about 75% amorphous phase. The phases identified in both deposit and overspray powder were: amorphous, α-Fe, Fe23B6, FeB and FeNbB. Amorphous phase formation in the thinner region of the deposit and the absence in the thicker region indicates that the resulting amorphous phase depend on the maintenance of amorphous phase formed during atomization that might be controlled by process parameters. Spray forming of Fe-based amorphous alloys followed by hot consolidation in T < T x for elimination of porosity opens the possibility of obtaining a bulk amorphous or nanocrystalline deposit (millimeters thick) with good soft magnetic properties and enlarging the applications range, which is limited by the reduced (micrometric) dimensions of common amorphous products