Verification and Validation of Encapsulation Flow Models in GOMA, Version 1.1; TOPICAL

Encapsulation is a common process used in manufacturing most non-nuclear components including: firing sets, neutron generators, trajectory sensing signal generators (TSSGs), arming, fusing and firing devices (AF and Fs), radars, programmers, connectors, and batteries. Encapsulation is used to contain high voltage, to mitigate stress and vibration and to protect against moisture. The purpose of the ASCI Encapsulation project is to develop a simulation capability that will allow us to aid in the encapsulation design process, especially for neutron generators. The introduction of an encapsulant poses many problems because of the need to balance ease of processing and properties necessary to achieve the design benefits such as tailored encapsulant properties, optimized cure schedule and reduced failure rates. Encapsulants can fail through fracture or delamination as a result of cure shrinkage, thermally induced residual stresses, voids or incomplete component embedding and particle gradients. Manufacturing design requirements include (1) maintaining uniform composition of particles in order to maintain the desired thermal coefficient of expansion (CTE) and density, (2) mitigating void formation during mold fill, (3) mitigating cure and thermally induced stresses during cure and cool down, and (4) eliminating delamination and fracture due to cure shrinkage/thermal strains. The first two require modeling of the fluid phase, and it is proposed to use the finite element code GOMA to accomplish this. The latter two require modeling of the solid state; however, ideally the effects of particle distribution would be included in the calculations, and thus initial conditions would be set from GOMA predictions. These models, once they are verified and validated, will be transitioned into the SIERRA framework and the ARIA code. This will facilitate exchange of data with the solid mechanics calculations in SIERRA/ADAGIO