Effect of the quench temperature on the mechanical properties of a medium C Mn high Si steel during Q&P heat treatment process

A steel of composition Fe-0.2C-3Mn-2Si-0.5Al was fully austenized followed by a quench and partitioning heat treatment process (Q&P). The quench temperature was varied, which resulted in different volume fractions of retained austenite (RA) and martensite. Analysis of the phase evolution and the resulting microstructures during the Q&P process were carried out using different techniques namely, - dilatometry, FEG SEM, EBSD, and neutron diffraction. Mechanical properties were evaluated by standard tensile tests on samples quenched to different temperatures. The partitioning process was evaluated by dilatometry. The volume fraction of the RA was determined by neutron diffraction. It was found that the volume fraction of RA increased with an increase in the quench temperature contrary to the Speer model. It was also observed that the presence of bainite, which formed during the quench and partitioning temperature significantly stabilized the RA by carbon partitioning. The tensile test results indicated the optimum quench temperature for the best combination of strength and ductility and contrary to expectation, this did not occur in the specimen with the maximum amount of RA. In other words, the mechanical properties of the steel undergoing a Q&P process is influenced by the quench temperatures and is also affected the phase evolution which occurs during both the quench and partitioning process. (paper)