Published June 15, 2007 | Version v1
Journal article

Extremely low recycling and high power density handling in CDX-U lithium experiments

  • 1. Princeton Plasma Physics Laboratory, P.O. Box 451, Princeton, NJ 08543 (United States)
  • 2. University of California at San Diego, La Jolla, CA (United States)
  • 3. Oak Ridge National Laboratory, Oak Ridge, TN (United States)
  • 4. Lawrence Livermore National Laboratory, Livermore, CA (United States)

Description

The mission of the Current Drive eXperiment-Upgrade (CDX-U) spherical tokamak is to investigate lithium as a plasma-facing component (PFC). The latest CDX-U experiments used a combination of a toroidal liquid lithium limiter and lithium wall coatings applied between plasma shots. Recycling coefficients for these plasmas were deduced to be 30% or below, and are the lowest ever observed in magnetically-confined plasmas. The corresponding energy confinement times showed nearly a factor of six improvement over discharges without lithium PFC's. An electron beam (e-beam) for evaporating lithium from the toroidal limiter was one of the techniques used to create lithium wall coatings in CDX-U. The evaporation was not localized to the e-beam spot, but occurred only after the entire volume of lithium in toroidal limiter was liquefied. This demonstration of the ability of lithium to handle high heat loads can have significant consequences for PFC's in future burning plasma devices

Additional details

Identifiers

DOI
10.1016/j.jnucmat.2007.01.229;
PII
S0022-3115(07)00250-4;

Publishing Information

Journal Title
Journal of Nuclear Materials
Journal Volume
363-365
Journal Page Range
p. 1231-1235
ISSN
0022-3115
CODEN
JNUMAM

Optional Information

Copyright
Copyright (c) 2007 Elsevier Science B.V., Amsterdam, The Netherlands, All rights reserved.