Multi-module modeling of heavy ion reactions and the third flow component

Fluid dynamical calculations with QGP showed a softening of the directed flow while with hadronic matter this effect is absent. On the other hand we indicated that a third flow component shows up in the reaction plane as an enhanced emission, which is orthogonal to the direct flow. This is not shadowed by the deflected projectile and target, and shows up at measurable rapidities, ycm= 1-2. To study the formation of this effect initial stages of relativistic heavy ion collisions are studied. An effective string rope model is presented for heavy ion collisions at RHIC energies. Our model take into account baryon recoil for both target and projectile, arising from the acceleration of partons in an effective field. The typical field strength (string tension) for RHIC energies is about 5-12 GeV/fm, what allow us to talk about 'string ropes'. The results show that QGP forms a tilted disk, such that the direction of the largest pressure gradient stays in the reaction plane, but deviates from those the beam and the usual transverse flow directions. The produced initial state can be used as an initial condition for further hydrodynamical calculations. Such initial conditions lead to the creation of third flow component. Recent ν1 measurements are promising that this effect can be used as a diagnostic tool of the QGP. Collective flow is sensitive to the early stages of system evolution. To study the sensitivity of the flow signal, we have calculated flow harmonics from a Blast Wave model, a tilted, ellipsoidally expanding source. We studied recent experimental techniques used for calculation of the νn Fourier coefficients and pointed out a few possible problems connected to these techniques, which may impair the sensitivity of flow analysis. (author)