Characterization of dissolved organic matter in anoxic rock extracts and in situ pore water of the Opalinus Clay

Dissolved organic matter (DOM) from the Opalinus Clay, a potential host rock for the disposal of radioactive waste, was isolated under strictly anoxic conditions from ground rock material and compared with DOM of in situ pore water samples. For the extractions, deionized water, synthetic pore water (SPW, water containing all major ions at pore water concentrations but no organic matter) and 0.1 M NaOH were used. The influence of the solid-to-liquid ratio, extraction time, acid-pretreatment and O2 exposure of the rock material on the isolated DOM were investigated. Liquid chromatography coupled with a total organic C detector (LC-OCD) and reverse-phase ion chromatography were used to characterize the DOM size distributions and to determine the low molecular weight organic acid (LMWOA) contents in the pore water samples and the rock extracts. The results revealed that only a small portion of the total organic C of the rock material (<0.38%) was extractable, even after removal of carbonates by acid-pretreatment. The concentrations of dissolved organic C (DOC) were found to range from 3.9 ± 0.4 to 8.0 ± 0.8 mg/L in the anoxic extracts. The pore waters exhibited similar DOC concentrations ranging from 1.2 to 15.8 ± 0.5 mg/L. The analysis by LC-OCD showed that the DOM extracted under anoxic conditions and the pore water DOM mainly consisted of hydrophilic compounds of less than 500 Da. The DOM extracted with SPW was most similar in size to the pore water DOM. Grinding the rock under oxic conditions increased the DOC yields and shifted the size distribution toward higher molecular weight compounds compared to the strictly anoxic treatment. Acetate, lactate and formate were identified in all extracts and in the pore water. In total, LMWOA accounted for 36% of the total DOC in both pore water and SPW extracts. The results imply that controlled anoxic conditions and the use of SPW as an extractant are required to isolate DOM from Opalinus Clay rocks which most resembles the in situ pore water DOM with respect to its size distribution and the LMWOA contents