Turbulent heat mixing of a heavy liquid metal flow in the MEGAPIE target geometry-The heated jet experiment

The MEGAPIE target installed at the Paul-Scherrer Institute is an example of a spallation target using eutectic liquid lead-bismuth (Pb45Bi55) both as coolant and neutron source. An adequate cooling of the target requires a conditioning of the flow, which is realized by a main flow transported in an annular gap downwards, u-turned at a hemispherical shell into a cylindrical riser tube. In order to avoid a stagnation point close to the lowest part of the shell a jet flow is superimposed to the main flow, which is directed towards to the stagnation point and flows tangentially along the shell. The heated jet experiment conducted in the THEADES loop of the KALLA laboratory is nearly 1:1 representation of the lower part of the MEGAPIE target. It is aimed to study the cooling capability of this specific geometry in dependence on the flow rate ratio (Q main/Q jet) of the main flow (Q main) to the jet flow (Q jet). Here, a heated jet is injected into a cold main flow at MEGAPIE relevant flow rate ratios. The liquid metal experiment is accompanied by a water experiment in almost the same geometry to study the momentum field as well as a three-dimensional turbulent numerical fluid dynamic simulation (CFD). Besides a detailed study of the envisaged nominal operation of the MEGAPIE target with Q main/Q jet = 15 deviations from this mode are investigated in the range from 7.5 ≤ Q main/Q jet ≤ 20 in order to give an estimate on the safe operational threshold of the target. The experiment shows that, the flow pattern establishing in this specific design and the turbulence intensity distribution essentially depends on the flow rate ratio (Q main/Q jet). All Q main/Q jet-ratios investigated exhibit an unstable time dependent behavior. The MEGAPIE design is highly sensitive against changes of this ratio. Mainly three completely different flow patterns were identified. A sufficient cooling of the lower target shell, however, is only ensured if Q main/Q jet ≤ 12.5. In this case the jet flow covers the whole lower shell. Although for Q main/Q jet ≤ 12.5 the flow is more unstable compared to the other patterns most of the fluctuations close to the centerline are in the high frequency range (>1 Hz), so that they will not lead to severe temperature fluctuations in the lower shell material. In this case the thermal mixing occurs on large scales and is excellent. For flow rate ratios Q main/Q jet > 12.5 complex flow patterns consisting of several fluid streaks and vortices were identified. Since in these cases the jet flow does not fully cover the lower shell an adequate cooling of the MEGAPIE target cannot be guaranteed and thus temperatures may appear exceeding material acceptable limits. All conducted experiments show a high sensitivity to asymmetries even far upstream. A comparison of the numerical simulation, which assumed a symmetric flow, with the experimental data was due to the experimentally found asymmetry only partially possible