Published August 2005 | Version v1
Journal article

Some regularities of deposition of an iron-tungsten alloy from citrate-ammoniate solutions

  • 1. RAN, Inst. Fizicheskoj Khimii, Moscow (Russian Federation)

Description

The process of the electrochemical deposition of an iron-tungsten alloy is investigated by measuring potentiostatic polarization curves. It is established that, though the solution is prepared on the basis of Fe(II) compounds, stable deposition of dense deposits of the alloy begins only after a larger fraction of these compounds converts into Fe(III) compounds as a result of oxidation by oxygen of air and anodic oxidation. The parallel evolution of hydrogen is accompanied by the process of incomplete reduction of iron ions. The current efficiency for the alloy under working conditions exceeds 50%. The content of tungsten in the obtained alloys is weakly dependent on the current density and amounts to nearly 45% (by weight)

Abstract (Russian)

Методом измерения потенциостатических поляризационных кривых изучен процесс электроосаждения сплава железо-вольфрам. Установлено, что, хотя раствор готовится на основе соединений Fe(II), устойчивое выделение плотных осадков сплава начинается только после перехода большей части этих соединений в соединения Fe(III) в результате окисления кислородом воздуха и анодного окисления. Наряду с параллельным выделением водорода имеет место процесс неполного восстановления ионов железа. Выход сплава по току в рабочих условиях превышает 50%. Содержание вольфрама в полученных сплавах слабо зависит от плотности тока и составляет около 45% (по массе)

Additional details

Additional titles

Original title (Russian)
Некоторые закономерности осаждения сплава железо-вольфрам из цитратно-аммиакатных растворов

Publishing Information

Journal Title
Ehlektrokhimiya
Journal Volume
41
Journal Issue
8
Journal Page Range
p. 1001-1004
ISSN
0424-8570
CODEN
ELKKAX

Optional Information

Notes
9 refs., 2 figs.