Impact of surface morphology of Si substrate on performance of Si/ZnO heterojunction devices grown by atomic layer deposition technique
- 1. Department of Electronics and Communication Engineering, Motilal Neheru National Institute of Technology, Allahabad 211004 (India)
- 2. Department of Electronics Engineering, Indian Institute of Technology (BHU), Varanasi 221005 (India)
Description
In this paper, the authors have investigated the structural, optical, and electrical characteristics of silicon nanowire (SiNW)/zinc oxide (ZnO) core–shell nanostructure heterojunctions and compared their characteristics with Si/ZnO planar heterojunctions to investigate the effect of surface morphology of Si substrate in the characteristics of Si/ZnO heterojunction devices. In this work, ZnO thin film was conformally deposited on both p-type 〈100〉 planar Si substrate and substrate with vertically aligned SiNW arrays by atomic layer deposition (ALD) method. The x-ray diffraction spectra show that the crystalline structures of Si/ZnO heterojunctions are having (101) preferred orientation, whereas vertically oriented SiNW/ZnO core–shell heterojunctions are having (002)-oriented wurtzite crystalline structures. The photoluminescence (PL) spectra of Si/ZnO heterojunctions show a very sharp single peak at 377 nm, corresponding to the bandgap of ZnO material with no other defect peaks in visible region; hence, these devices can have applications only in UV region. On the other hand, SiNW/ZnO heterojunctions are having band-edge peak at 378 nm along with a broad emission band, spreading almost throughout the entire visible region with a peak around 550 nm. Therefore, ALD-grown SiNW/ZnO heterojunctions can emit green and red light simultaneously. Reflectivity measurement of the heterojunctions further confirms the enhancement of visible region peak in the PL spectra of SiNW/ZnO heterojunctions, as the surface of the SiNW/ZnO heterojunctions exhibits extremely low reflectance (<3%) in the visible wavelength region compared to Si/ZnO heterojunctions (>20%). The current–voltage characteristics of both Si/ZnO and SiNW/ZnO heterojunctions are measured with large area ohmic contacts on top and bottom of the structure to compare the electrical characteristics of the devices. Due to large surface to-volume ratio of SiNW/ZnO core–shell heterojunction devices, the output current rating is about 130 times larger compared to their planar version at 2 V forward bias voltage. This higher output current rating can be exploited for fabricating high-performance nanoelectronic and optoelectronic devices in near future
Additional details
Identifiers
- DOI
- 10.1116/1.4900719;
Publishing Information
- Journal Title
- Journal of Vacuum Science and Technology. A, Vacuum, Surfaces and Films
- Journal Volume
- 33
- Journal Issue
- 1
- Journal Page Range
- vp.
- ISSN
- 0734-2101
- CODEN
- JVTAD6
INIS
- Country of Publication
- United States
- Country of Input or Organization
- International Atomic Energy Agency (IAEA)
- INIS RN
- 46024281
- Subject category
- S42: ENGINEERING;
- Descriptors DEI
- DEPOSITION; HETEROJUNCTIONS; NANOSTRUCTURES; PERFORMANCE; PHOTOLUMINESCENCE; SUBSTRATES; SURFACES; X-RAY DIFFRACTION; ZINC OXIDES
- Descriptors DEC
- CHALCOGENIDES; COHERENT SCATTERING; DIFFRACTION; EMISSION; LUMINESCENCE; OXIDES; OXYGEN COMPOUNDS; PHOTON EMISSION; SCATTERING; SEMICONDUCTOR JUNCTIONS; ZINC COMPOUNDS
Optional Information
- Notes
- (c) 2014 American Vacuum Society