Impact of titanium addition on film characteristics of HfO2 gate dielectrics deposited by atomic layer deposition

The impact of 8-to 45-at. % Ti on physical and electrical characteristics of atomic-layer-deposited and annealed hafnium dioxide was studied using vacuum-ultraviolet spectroscopic ellipsometry, secondary ion mass spectroscopy, transmission electron microscopy, atomic force microscopy, x-ray diffraction, Rutherford backscattering spectroscopy, x-ray photoelectron spectroscopy, and x-ray reflectometry. The role of Ti addition on the electrical performance is investigated using molybdenum (Mo)-gated capacitors. The film density decreases with increasing Ti addition. Ti addition stabilizes the amorphous phase of HfO2, resulting in amorphous films as deposited. After a high-temperature annealing, the films transition from an amorphous to a polycrystalline phase. Orthorhombic Hf-Ti-O peaks are detected in polycrystalline films containing 33-at. % or higher Ti content. As Ti content is decreased, monoclinic HfO2 becomes the predominant microstructure. No TiSi is formed at the dielectric/Si interface, indicating films with good thermal stability. The band gap of Hf-Ti-O was found to be lower than that of HfO2. Well-behaved capacitance-voltage and leakage current density-voltage characteristics were obtained for Hf-Ti-O. However, an increased leakage current density was observed with Ti addition. The data from capacitance-voltage stressing indicate a smaller flatband voltage (Vfb) shift in the HfO2 films with low Ti content when compared with the HfO2 films. This indicates less charge trapping with a small amount of Ti addition