Photostimulated luminescence of corrugated fiberboard as an additional screening method for detecting radiated foods

In this study, PSL of non-irradiated and irradiated corrugated fiberboards (CFs) was investigated to evaluate the possibility that CFs can be used as alternative specimens for the screening detection method of food irradiation. The irradiation at a dose of only 0.15 kGy increased PSL signals of the CF over 1 order of magnitude. The PSL signals increased with increasing in gamma irradiation dose and became almost saturated at a dose of 5 kGy. The core of CFs showed PSL signals sufficient for distinguishing irradiated from non-irradiated at least 6 months after irradiation even though the CF was exposed to light and the environmental temperature increased to 50 °C. These results suggest that the PSL property of the core of CFs is useful for detecting irradiation. However, the large variation of PSL signals among CFs made it difficult to set a well-defined "positive" threshold limit to distinguish irradiated from non-irradiated completely. All of the non-irradiated CFs showed PSL signals above 103 counts, which is much higher than that detected for foods. It is apparent that the threshold limit of EN 13751 is not applicable to detecting irradiated CFs. More detailed collaborative research with large number of samples is needed to establish new threshold limits involving "intermediate" classification. - Highlights: ► Corrugated fiberboards (CF) as a packaging material were gamma-irradiated. ► The photostimulated luminescence (PSL) signals of irradiated CF were measured. ► The PSL signals were sufficient for detecting irradiation. ► The signals were well retained for 6 months after irradiation upon exposure to light. ► The environmental temperature at 50 °C had little effects on the signal retention.