Design and development of a cryogenic semiconductor amplifier for interfacing RSFQ circuits at 4.2 K

There is a great deal of interest in amplifiers with extremely high bandwidth, low noise and low power consumption which interface RSFQ circuits with commercial room temperature electronics or amplifying SFQ pulses. In this special application a hybrid amplifier should interface an RSFQ circuitry with a Josephson junction array quantizer chip (JA-Q) at 4.2 K. The input signal for the amplifier is generated by an RSFQ signal generator and the output signal fed-in to a Josephson array quantizer. A voltage gain of about 104 with a pattern frequency of 2 GHz for a good transfer of the SFQ pulses is required. Additionally, the JA-Q requires a high output current at low power consumption of the amplifier at the same time. Various hybrid amplifiers based on commercially available p-HEMT transistors in an embedded microwave design were designed and characterized. For the p-HEMT transistor characterization at cryogenic temperatures the biasing settings according to an optimum between voltage gain AV and low power consumption PV were determined. Thus a power consumption of PV = 2 mW and a voltage gain of about AV = 4 per stage were achieved. For a preamplifier and an amplifier concept a number of these stages were implemented in a microstrip and a coplanar transmission line design with a special matched interconnect taper towards the RSFQ components. Measurements of the amplifiers and the combination of the amplifiers and the JA-Q at 4.2 K showed their good performance without any disturbances of the quantized voltage steps