Study of heat and mass transfer phenomena in fuel assembly models under accident conditions

The majority of the material in support of the thermal - hydraulic safety of WWER core was obtained on single - assembly models containing a relatively small number of elements - heater rods. Upgrading the requirements to the reactor safety leads to the necessity for studying phenomena in channels representing the cross - sectional core dimensions and non - uniform radial power generation. Under such conditions, the contribution of natural convection can be significant in some core zones, including the occurrence of reverse flows and interchannel instability. These phenomena can have an important influence on heat transfer processes. Such influence is especially drastical under accident conditions associated with ceasing the forced circulation over the circuit. A number of urgent reactor safety problems at low operating parameters is related with the computer code verification and certification. One of the important trends in the reactor safety research is concerned with the rod bundle reflooding and verificational calculations of this phenomenon. To assess the water cooled reactor safety, the best fit computer codes are employed, which make it possible to simulate accident and transient operating conditions in a reactor installation. One of the most widely known computer codes is the RELAP5/MOD3 Code. The paper presents the comparison of the results calculated using this computer code with the test data on 4 - rod bundle quenching, which were obtained at the SSCRF-IPPE. Recently, the investigations on the steam - zirconium reaction kinetics have been performed at the SSCFR-IPPE and are being presently performed for the purpose of developing new and verifying available computer codes. (author). 3 refs, 6 figs