Published August 2004 | Version v1
Journal article

EPMA analysis of inter-reaction layer in irradiated U3Si-Al fuels

  • 1. Korea Atomic Energy Research Institute, Daejeon (Korea, Republic of)
  • 2. Chungbuk National Univ., Cheongju (Korea, Republic of)

Description

Fission products and inter reaction layer of U3Si-Al dispersion fuel, irradiated in HANARO research reactor with 121 kW/m of maximum liner power and 63 at% of average burn-up, was characterization by EPMA (Electron Probe Micro Analyzer). The fuel punching system developed by Irradiated Materials Examination Facility (IMEF) has used to make these samples for the EPMA. With this system a very small and thin specimen which is 1.57 mm in diameter and 2 mm in thickness respectively has been fabricated to protect the EPMA operator from high radioactive fuel and to minimize the equivalent dose rate less than 150 mSv/h. EPMA was performed to observe layers of sectional, inter-reaction and oxide with specimens of cutting and polished. Stoichiometry in the inter-reaction layer with 16 μm of thickness was U2.84 Si Al14 with calibration of UO2 and U3.24 Si Al14.1 with calibration of standard specimen. Metallic precipitates in this layer were not observed using fission products examination

Additional details

Publishing Information

Journal Title
Analytical Science and Technology
Journal Volume
17
Journal Issue
4
Series
8 refs, 6 figs, 1 tab
Journal Page Range
p. 355-362
ISSN
1225-0163