Application of TRACE/PARCS to BWR stability analysis

The work described here is the validation of TRACE/PARCS for Boiling Water Reactor stability analysis. A stability methodology was previously developed, verified, and validated using data from the OECD Ringhals stability benchmark. The work performed here describes the application of TRACE/PARCS to all the stability test points from Cycle 14 of the Ringhals benchmark. The benchmark points from Cycle 14 were performed using a half-core symmetric, 325 channel TRACE model. Several parametric studies are performed on test point 10 of Cycle 14. Two temporal difference methods, Semi- Implicit method (SI) and Stability Enhanced Two Step (SETS) method are applied to three different mesh sizes in heated channels with series of time step sizes. The results show that the SI method has a smaller numerical damping than the SETS method. When applying the SI method with adjusted mesh and Courant time step sizes (the largest time step size under the Courant limit), the numerical damping is minimized, and the predicted Decay Ratio (DR) agrees well with the reference values which were obtained from the measured noise signal. The SI method with adjusted mesh and Courant time step size is then applied to all test points of Cycle 14 with 3 types of initiating perturbations, control rod (CR), pressure perturbation, and noise simulation (NS). There is good agreement between the Decay ratios and frequencies predicted by TRACE/PARCS and those from the plant measurements. Sensitivities were also performed to investigate the impact on the decay ratio and natural frequency of the heat conductivity of the gap between fuel and clad, as well as the impact of the pressure loss coefficient of spacers. (authors)