A Procedure for the Rapid Determination of ²²⁶Ra and ²²⁸Ra in Drinking Water by Liquid Scintillation Counting

Since 2004, the environment programme of the IAEA has included activities aimed at the development of a set of procedures for the determination of radionuclides in terrestrial environmental samples. Reliable, comparable and 'fit for purpose' results are essential requirements for any decision based on analytical measurements. For the analyst, tested and validated analytical procedures are extremely important tools for the production of such data. For maximum utility, such procedures should be comprehensive, clearly formulated and readily available to both the analyst and the customer. This publication describes a procedure for the rapid determination of ²²⁶Ra and ²²⁸Ra in drinking water. The determination of radium in drinking water is important for protecting human health, since the consumption of drinking water containing radium may lead to an accumulation in the body, contributing to the radiological dose. The method is based on the separation of ²²⁶Ra and ²²⁸Ra from interfering elements using PbSO₄ and Ba(Ra)SO₄ coprecipitation steps. The isotopes ²²⁶Ra and ²²⁸Ra are then determined by liquid scintillation counting. The procedure is expected to be of general use to a wide range of laboratories, including the laboratories of the Analytical Laboratories for the Measurement of Environmental Radioactivity (ALMERA) network, both in emergency situations and for routine environmental monitoring purposes. The method was established after an extensive review of papers from the scientific literature, and was tested and validated in terms of repeatability and trueness (relative bias) in accordance with International Organization for Standardization guidelines. Reproducibility tests were performed at expert laboratories. The calculation of massic activities, uncertainty budget, decision threshold and detection limit are also described