Results 1 - 10 of 27250
Results 1 - 10 of 27250. Search took: 0.05 seconds
|Sort by: date | relevance|
[en] This project proposes to use for sea the technique of pumped Storage Hydroelectric, implemented in mountain areas. The method stores energy in form of water, pumped from a lower elevation reservoir to a higher elevation. Low-cost off-peak electric power is used to run the pumps. During periods of high electrical demand, the stored water is released through turbines. This new concept in pumped storage is to use wind turbines to drive water pumps directly, providing a more efficient process and usefully smooth out the variabilities of energy captured from the wind. (A.L.B.)
[en] This serial research intends to put a unique power stabilization system with a pumped storage into practical use. The pumped storage is equipped with a counter-rotating type pump-turbine unit whose operating mode can be shifted instantaneously in response to the fluctuation of power from renewable resources. This paper verifies that the system is reasonably effective to stabilize the fluctuating power. It is necessary to quickly increase the rotational speed when the operation is shifted from the turbine to the pumping modes, because the unit cannot pump-up water from a lower reservoir at a slow rotational speed while keeping gross/geodetic head constant. The maximum hydraulic efficiency at the turbine mode is close to the efficiency of the counter-rotating type hydroelectric unit designed exclusively for the turbine mode. The system is also provided for a pilot plant to be operated in the field
[en] An optical pump cavity is used for side pumping a small diameter Nd:YAG rod with a stacked diode laser array. This cavity provides compact geometry compared to a fiber coupled or a circularly symmetric, close coupled arrangement. With the 300 W pump power of the stacked diode array having 15 mm X 10 mm emitting area, 42 W laser power is obtained from the 0.9at.% Nd:YAG crystal rod with the size of 3 mm X 45 mm. The optical-to optical conversion efficiency between diode array output and Nd:YAG laser is 18%. The laser output beam shows uniform intensity distribution.
[en] Pumped storage power plants have long been used to regulate the production relative variations in consumption, but there is no preliminary pumping power plant in Norway built to regulate on short terms. To increase the knowledge about the possibilities to establish a pumping power plant in Norway, NVE has therefore been made a study of how pumping power can be drawn up and what it costs to build pumped storage plant between already existing magazine. One can not just based on cost and design conclude anything about the potential for pumped storage plant in Norway, but it is a start of a work that might make it easier to assess to what extent this may be possible. (eb)
[en] Though axisymmetric modelling is not widely used it can be incorporated into MODFLOW by tricking the grids with a log-scaling method to simulate the radial flow to a well and to upgrade hydraulic properties. Furthermore, it may reduce computer runtimes considerably by decreasing the number of dimensions. The Almonte-Marismas aquifer is a heterogeneous multi-layer aquifer underlying the Donana area, one of the most important wetlands in Europe. The characterization of hydraulic conductivity is of great importance, because this factor is included in the regional groundwater model, the main water-management support tool in the area. Classical interpretations of existing pumping tests have never taken into account anisotropy, heterogeneity and large head gradients. Thus, to improve the characterization of hydraulic conductivity in the groundwater model, five former pumping tests, located in different hydrogeological areas, have been modelled numerically to represent radial flow in different parts of the aquifer. These numerical simulations have proved to be suitable for reproducing groundwater flow during a pumping test, to corroborate hypotheses concerning unconfined or semi-confined aquifers and even to estimate different hydraulic conductivity values for each lithological layer drilled, which constitutes the main improvement of this model in comparison with classical methods. A comparison of the results shows that the values of the numerical model are similar to those obtained by classical analytic techniques but are always lower for the most permeable layer. It is also clear that the less complex the lithological distribution the more accurate the estimations of hydraulic conductivity. (Author) 46 refs.
[en] The dynamics of dipolariton states in a planar microcavity has been studied upon pumping of a state corresponding to the middle dipolariton branch. It has been shown that, under exact resonance conditions, both periodic and aperiodic regimes of conversion of pump dipolaritons to dipolaritons of idler and signal modes occur. The periodic regime of conversion of signal and idler dipolaritons without involving pump dipolaritons on the middle branch has also been analyzed.
[en] In this paper, vacuun technology with kinematic motion of gas and vacuum pumps is briefly studied. Also the importance of studying surface science is mentaoned. The techniques of surface study are explained. The present level of surface study in Korea is also mentioned in a viewpoint of basic science and technolog development (Author)
[en] Highlights: • A modular pumped-storage scheme using elevated water storage towers is investigated. • The pumped-storage scheme also aides in the wastewater treatment process. • A preliminary hydraulic pump-turbine runner design is created based on existing literature. • The preliminary design is optimized using a response surface optimization methodology. • The performance and flow fields between preliminary and optimized designs are compared. - Abstract: A novel modular pumped-storage scheme is investigated that uses elevated water storage towers and cement pools as the upper and lower reservoirs. The scheme serves a second purpose as part of the wastewater treatment process, providing multiple benefits besides energy storage. A small pumped-storage scheme has been shown to be a competitive energy storage solution for micro renewable energy grids; however, pumped-storage schemes have not been implemented on scales smaller than megawatts. Off-the-shelf runner designs are not available for modular pumped-storage schemes, so a custom runner design is sought. A preliminary hydraulic design for a pump-turbine runner is examined and optimized for increased pumping hydraulic efficiency using a response surface optimization methodology. The hydraulic pumping efficiency was found to have improved by 1.06% at the best efficiency point, while turbine hydraulic efficiency decreased by 0.70% at the turbine best efficiency point. The round-trip efficiency for the system was estimated to be about 78%, which is comparable to larger pumped-storage schemes currently in operation
[en] Effects of air vessel on water hammer process in a pumping station with high-head were analyzed by using the characteristics method. The results show that the air vessel volume is the key parameter that determines the protective effect on water hammer pressure. The maximum pressure in the system declines with increasing air vessel volume. For a fixed volume of air vessel, the shape of air vessel and mounting style, such as horizontal or vertical mounting, have little effect on the water hammer. In order to obtain good protection effects, the position of air vessel should be close to the outlet of the pump. Generally, once the volume of air vessel is guaranteed, the water hammer of a entire pipeline is effectively controlled
[en] We study the behavior of the optical bistability (OB) and multistability (OM) in a two-level pumped-probe atomic system by means of a unidirectional ring cavity. We show that the optical bistability in a two-level atomic system can be controlled by adjusting the intensity of the pump field and the detuning between two fields. We find that applying the pumping field decreases the threshold of the optical bistability.