Results 1 - 2 of 2
Results 1 - 2 of 2. Search took: 0.015 seconds
|Sort by: date | relevance|
[en] Highlights: • Thermodynamic analysis is presented for a LAES system combined with packed bed units. • The LAES system round-trip efficiency is in the range 50–62%. • Cold box inlet temperature and discharge pressure have significant influence on system performance. • LAES system has smaller air storage volume and higher ASED compared with A-CAES system. - Abstract: Energy storage is a key technology required to manage intermittent or variable renewable energy, such as wind or solar energy. In this paper a concept of an energy storage based on liquid air energy storage (LAES) with packed bed units is introduced. First, the system thermodynamic performance of a typical cycle is investigated and temperature distribution in cold boxes is discussed. Then, the effects of inlet temperature of cold boxes, charge and discharge pressures on thermal behaviors of LAES system are analyzed, as well as the system round-trip efficiency. Finally, an overall comparison between this LAES system and an adiabatic compressed air energy storage (A-CAES) system is conducted. The system could achieve a round-trip efficiency in the range 50–62% depending on the values of process conditions. The system round-trip efficiency decreases with the increase of cold box inlet temperature, and increases with the rise of charge and discharge pressures. Although the round-trip efficiency of the present LAES system is a bit lower than the A-CAES system, however, the air storage volume decreases and the air storage energy density (ASED) increases remarkably for the same operational conditions. The main conclusions draw from this work is beneficial for future LAES development in particular the combination with the packed bed units and the fit with the requirements for large-scale energy storage.
[en] Highlights: • The influence of disk configurations on droplets characteristics is investigated. • The droplets size, droplets size distributions, filament mass fraction and particle uniformity were analyzed. • A correlation of dm for four types of disks is presented. • The majority of the droplets size is populated in the range of 0.2–1.0 mm. • The flat/arc-edge disks represent a superior uniformity compared with the other disks. - Abstract: The influence of rotary disk configurations on droplets characteristics in molten slag ligament granulation was investigated by using the high-speed camera visualized system. Rosin/Paraffin mixture was adopted as the analogue of the molten slag according to the similarity theory. Four groups of disks with different configurations were studied. The droplets characteristics, such as droplets size, droplets size distributions, filament mass fraction and particle uniformity were analyzed. Generally, the droplets mean diameters (dm) decreases by increasing the rotary speed (ω) or disk diameter (D), and increases slightly by increasing the liquid flow rate (Q). Based on the experimental data, a simple correlation of dm for four types of disks is presented. The majority of the droplets size is populated in the range of 0.2–1.0 mm for all ω and Q, which accounts for over 70% mass fraction. The ω has significant influence on droplets size distribution and particle uniformity. The flat/arc-edge disk configurations can contribute to produce the narrower size range of droplets and obtain the superior particle uniformity compared to the other two types of disks. In the ligament breakup mode, the filament mass fraction reduces by increasing Q or decreasing ω. Meanwhile, the liquid film breakup mode also has significant impact on the formation of filament.